Service Manual

3 Using the alignment posts, place the I/O board on the palm-rest assembly

and align the screw holes on the I/O board with the screw holes on the palm-

rest assembly.

4 Replace the two screws (M2.5x5) that secure the I/O board to the palm-rest

assembly.

5 Slide the I/O-board cable into the connector on the I/O board and close the

latch to secure the cable.

6 Adhere the tape that secures the I/O-board cable to the I/O board.

Post-requisites

1 Replace the computer base.

2 Replace the rear-I/O cover.

3 Replace the solid-state drive.

4 Replace the wireless card.

5 Follow the procedure from step 4 to step 7 in “Replacing the hard drive”.

6 Replace the base cover.