Service Manual

Diagnostics
Power and battery-status light: Indicates the power and battery-charge status.
Solid amber – Computer is running on battery and the battery has less than 10 percent charge.
User-defined color (AC mode) – Power adapter is connected and the battery is fully charged.
User-defined color (Battery mode) – Computer is running on battery and the battery has more than 10 percent charge.
User-defined color (Breathing, that is, slow decrease/increase in illumination) – Computer is in sleep state.
Off – Computer is in hibernation, or turned off.
The power and battery-status light blinks red and blue along with beep codes indicating failures.
For example, the power and battery-status light blinks red two times followed by a pause, and then blinks blue three times followed
by a pause. This 2,3 pattern continues until the computer is turned off indicating no memory or RAM is detected.
The following table shows different light patterns and what they indicate.
Table 8. Diagnostics
Diagnostic light codesProblem description
2,1Processor failure
2,2System board: BIOS or ROM (Read-Only Memory) failure
2,3No memory or RAM (Random-Access Memory) detected
2,4Memory or RAM (Random-Access Memory) failure
2,5Invalid memory installed
2,6System-board or chipset error
2,7Display failure
3,1Coin-cell battery failure
3,2PCI, video card/chip failure
3,3Recovery image not found
3,4Recovery image found but invalid
3,5Power-rail failure
3,6System BIOS Flash incomplete
3,7Management Engine (ME) error
Camera status light: Indicates whether the camera is in use.
•Solid white – Camera is in use.
•Off – Camera is not in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.
•Solid white – Caps Lock enabled.
•Off – Caps Lock disabled.
Network port light: Indicates network connectivity.
•Off – No network connection.
•Solid green – 10 Mbps connection.
•Solid orange – 100 Mbps connection.
•Solid yellow – 1000 Mbps connection.
•Flicker yellow – Network activity.
86