Service Manual

Table 4. System setup options—Advanced menu
Advanced
Intel(R) SpeedStep TechnologyAllows you to enable or disable Intel (R) Speedstep
Technology.
NOTE: If enabled, the processor clock speed and core
voltage are adjusted dynamically based on the processor
load.
Default: Enabled
VirtualizationAllows you to enable or disable the Intel Virtualization
technology.
Default: Enabled
VT for Direct I/OSpecify whether a Virtual Machine Monitor (VMM) can utilize
the additional hardware capabilities provided by Intel
Virtualization Technology for Direct I/O.
Integrated NICAllows you to enable or disable the on-board LAN controller.
Default: Enabled
USB EmulationAllows you to enable or disable the USB emulation feature. This
feature defines how the BIOS, in the absence of a USB-aware
operating system, handles USB devices. USB emulation is
always enabled during POST.
NOTE: You cannot boot any type of USB device (floppy,
hard drive, or memory key) when this option is off.
Default: Enabled
USB PowerShareAllows you to charge USB devices when the computer is turned
off or in standby mode.
Default: Enabled
USB Wake SupportAllows you to enable USB devices to wake the computer from
standby or to disable the USB wake support feature.
NOTE: If USB PowerShare is enabled, a device
connected to the USB PowerShare connector may not
wake the computer.
Default: Disabled
SATA OperationAllows you to configure the operating mode of the integrated
SATA hard drive controller.
Default: AHCI
Adapter WarningsAllows you to choose if the computer should display warning
messages when you use AC adapters that are not supported by
your computer.
Default: Enabled
Function Key BehaviorAllows you to set function key or multimedia key as the default
function key behavior.
Default: Function key
Express ChargeAllows you to charge your computer battery using Standard
Charge or Express Charge mode.
Default: Express Charge
Touchpad BacklightAllows you to configure the touchpad backlight option.
Battery HealthDisplays the battery health.
82