Service Manual

Removing the camera

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the

steps in Before working inside your computer. After working inside your computer, follow the instructions in After working

inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/

regulatory_compliance.

Prerequisites

1. Remove the

base cover.

2. Remove the wireless card.

3. Remove the solid-state drive.

4. Remove the rear-I/O cover.

5. Remove the

computer base.

6. Remove the memory modules.

7. Remove the display assembly.

8. Remove the display bezel.

Procedure

1. Using a plastic scribe, pry the camera module from the display back-cover and antenna assembly.

2. Disconnect the camera cable from the camera module.

3. Lift the camera module from the display back-cover and antenna assembly.