Service Manual

   
:                          .
                 .       
    www.dell.com/regulatory_compliance.
Procedure
1.Align the screw holes on the display hinges with the screw holes on the display back-cover and antenna assembly.
2.Replace the 12 screws (M2.5x3) that secure the display hinges to the display back-cover and antenna assembly.
3.Replace the tape that secures the display hinge to the display back-cover and antenna assembly.
4.Route the antenna cables, power-button board cable, logo-board cable, tobii eye-tracker board cable, and display cable
through the routing guides on the display back-cover and antenna assembly.
5.Turn the display assembly over.
6.Place the hinge caps on the display hinges and press down to snap them into place.
Post-requisites
1.Replace the
display bezel.
2.Replace the display assembly.
3.Replace the memory modules.
4.Replace the computer base.
5.Replace the rear-I/O cover.
6.Replace the solid-state drive.
7.Replace the
wireless card.
8.Replace the base cover.
77