Service Manual

Replacing the display bezel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
NOTE: This chapter is applicable only if you have purchased a laptop
with non-touchscreen display.
1 Adhere the logo board on the display bezel.
2 Connect the logo-board cable to the logo board and adhere the
adhesive tape.
3 Slide the display-board cables to their respective connectors on the logo
board and press down the latches to secure the cables.
4 Turn the display bezel over.
5 Align the display bezel with the display back-cover and gently snap the
display bezel into place.
Post-requisites
1 Replace the display assembly.
2 Follow the procedure from step 5 to step 11 in “Replacing the palm rest”.
3 Replace the wireless card.
4 Replace the base panel.
104