Service Manual

Removing the base cover
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Remove the six screws (M2.5x13) that secure the base cover to the computer base.
2 Loosen the captive screw that secures the base cover to the computer base to open a gap between the two parts.
3 Using a plastic scribe, gently pry the base cover from the gap around the captive screw to release the clips on the base
cover from the computer base.
11