Service Manual

Removing the camera cable

WARNING: Before working inside your computer, read the safety

information that shipped with your computer and follow the steps in

Before working inside your computer. After working inside your

computer, follow the instructions in After working inside your computer.

For more safety best practices, see the Regulatory Compliance home

page at

www.dell.com/regulatory_compliance.

Prerequisites

NOTE: These instructions are applicable only for laptops with a non-

touch screen display.

1 Remove the base cover.

2 Remove the wireless card.

3 Remove the solid-state drive.

4 Remove the memory modules.

5 Remove the rear-I/O cover.

6 Remove the computer base.

7 Remove the coin-cell battery.

8 Remove the heat-sink assembly.

9 Remove the battery.

10 Remove the system board.

11 Remove the display assembly.

12 Remove the display bezel.

13 Remove the display panel.

14 Remove the display hinges.

Procedure

1 Peel the tape that secures the camera cable to the camera module and

disconnect the camera cable from the camera module.