Service Manual

Removing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your computer.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the wireless card.
3 Remove the solid-state drive.
4 Remove the memory modules.
5 Remove the rear-I/O cover.
6 Remove the computer base.
7 Remove the coin-cell battery.
8 Remove the heat-sink assembly.
9 Remove the battery.
10 Remove the system board.
Procedure
1 Remove the antenna cables from the routing guides on the palm-rest
assembly.
2 Remove the logo-board cable from the routing guides on the palm-rest
assembly.
71