Service Manual

10 Turn the computer over.

11 Slide the display cable into the connector on the system board and close the

latch to secure the cable.

12 Connect the power-button board cable to the system board.

13 Connect the logo-board cable to the system board.

Post-requisites

1 Replace the heat-sink assembly.

2 Replace the battery.

3 Replace the coin-cell battery.

4 Replace the computer base.

5 Replace the rear-I/O cover.

6 Replace the memory modules.

7 Replace the solid-state drive.

8 Replace the wireless card.

9 Replace the base cover.