Service Manual

Replacing the status-light
board
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before working inside your computer.
After working inside your computer, follow the instructions
in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Slide the status-light board cable into the status-light board connector
and press down the latch to secure the cable.
2 Align the screw hole on the status-light board with the screw hole on the
palm-rest assembly.
3 Replace the screw that secures the status-light board to the palm-rest
assembly.
Post-requisites
1 Follow the procedure from step 3 to step 4 in “Replacing the keyboard”.
2 Follow the procedure from step 5 to step 9 in “Replacing the palm rest”.
3 Follow the procedure from step 3 to step 7 in “Replacing the solid-state
drive”.
4 Replace the base panel.
55