Owner's Manual

Configuring Dell Integration Pack Activities 67
4 For information about the settings on the General and Run Behavior tabs,
see Common Configuration Instructions for All Activities.
5 Click Finish .
NOTE: If you do not include the optional Timeout property the activity will not
wait for the specified persona or VMRack to start. Since persona booting
takes some time, you can choose to poll the state if you are not using the
timeout property.
Configuring the Stop Activity
To configure the Stop activity:
1
From the Activities pane, drag a Stop activity to the active runbook.
2 Double-click the Stop activity.
The
Properties dialog box is displayed.
3 Configure the Properties tab:
a In the Configuration section, click the ellipsis button (...), and then
select the Dell AIM configuration that you want to use for this
activity. Click
OK .
b In the Properties section, enter a value for each of the required
properties and the applicable optional properties. If the property is
Lookup-enabled, you can click the ellipsis (…) button next to the text
box to browse for a value.
You can also use returned data to automatically populate the value of the
property from the data output by a previous activity in the workflow.
To use returned data
a Right-click the property value box, click Subscribe , and then click
Returned Data .
b Click the Activity drop-down box and select the activity from which
you want to obtain the data.
c To view additional data elements common across the runbook, select
Show Common Returned Data .
d Click the returned data element you want to use, and then click OK .
AIMOpalis_bk0.book Page 67 Monday, October 24, 2011 10:16 AM