Owner's Manual

64 Configuring Dell Integration Pack Activities
Configuring the Maintenance Mode Activity
To configure the Maintenance Mode activity:
1
From the Activities pane, drag a Maintenance Mode activity to the active
runbook.
2 Double-click the Maintenance Mode activity.
The
Properties dialog box is displayed.
3 Configure the Properties t ab:
a In the Configuration section, click the ellipsis button (...), and then
select the Dell AIM configuration that you want to use for this
activity. Click
OK .
b In the Properties section, enter a value for each of the required
properties and the applicable optional properties. If the property is
Lookup-enabled, you can click the ellipsis (…) button next to the text
box to browse for a value.
You can also use returned data to automatically populate the value of the
property from the data output by a previous activity in the workflow.
To use returned data
a Right-click the property value box, click Subscribe , and then click
Returned Data .
b Click the Activity drop-down box and select the activity from which
you want to obtain the data.
c To view additional data elements common across the runbook, select
Show Common Returned Data .
d Click the returned data element you want to use, and then click OK .
For a list of the data elements returned by each activity, see the Returned
Data tables in the activity topic.
4 For information about the settings on the General and Run Behavior tabs,
see Common Configuration Instructions for All Activities.
5 Click Finish .
AIMOpalis_bk0.book Page 64 Monday, October 24, 2011 10:16 AM