Owner's Manual

Configuring Dell Integration Pack Activities 63
For a list of the data elements returned by each activity, see the Returned
Data tables in the activity topic.
4 Configure the settings in the Filters tab:
a In the Filters section click Add . In the Name box, click the down
arrow and select a property from the list.
b In the Relation box, click the down arrow and select a filter type.
c In the Va lu e box, enter the value you want to use. For more
information about using filters see Filters Tab.
You can also use returned data to automatically populate the value of the
property from the data output by a previous activity in the workflow.
To use returned data:
a Right-click the property value box, click Subscribe , and then click
Returned Data .
b Click the Activity drop-down box and select the activity from which
you want to obtain the data.
c To view additional data elements common across the runbook, select
Show Common Returned Data .
d Click the returned data element you want to use, and then click OK .
For a list of the data elements published by each activity, see the Returned
Data tables in the activity topic.
e Click OK to save the filter settings.
f Add additional filters as needed, and then click Finish .
5 To make changes to a filter, click the filter and then click Edit . Make the
changes, and then click
OK .
6 To remove a filter, click the filter and then click Remove .
For information about the settings on the
General and Run Behavior tabs,
see Common Configuration Instructions for All Activities.
7 Click Finish .
AIMOpalis_bk0.book Page 63 Monday, October 24, 2011 10:16 AM