Owner's Manual

Template – Deploy VMs to Cluster
Template – Install ESXi to SD card with FC Storage
Template – Install ESXi to SD Card with iSCSI Storage
Template – Deploy Hyper-V Host with iSCSI Storage
Template – Deploy Hyper-V Cluster with Fibre Channel Storage to SCVMM
Template – Deploy VMWare Cluster with NetApp Storage
Template – Boot from Fibre Channel SAN
Template – Boot from iSCSI SAN
Template – Deploy Virtual Machine Template Clone on Hyper-V Cluster
Template – Deploy Virtual Machine Template Clone on VMWare Cluster
Template – Deploy Hyper-V Cluster with Fibre Channel Storage to SCVMM
The
Deploy Hyper-V Cluster with Fibre Channel Storage to SCVMM template deploys two Fibre Channel
storage volumes, installs Hyper-V on two physical hosts, and creates a cluster with the Hyper-V hosts.
To deploy Hyper-V Cluster with Fibre Channel Storage to SCVMM using this template, perform the
following steps:
1. On the
Templates page, select the Deploy Hyper-V Cluster with Fibre Channel Storage to SCVMM
template, and click
Clone in the right pane.
2. In the
Create Template dialog box, enter a name, category, and description for the template, and
click Save.
3. On the
Template Builder page, click each storage components, click Edit on the dialog box that is
displayed, and then configure the following settings in the Storage Component dialog box:.
a. Modify the Component Name with a unique name, if required.
b. From the Target Compellent drop-down list, select the target compellent array.
c. Modify the Storage Volume Name and Storage Size, if desired.
NOTE: Make sure that you enter the storage size for the first volume is large enough to
support your Hyper-V host or cluster storage. However, the storage size for the second
volume can be small because it is configured as a quorum volume if this host will be used
for a Hyper-V cluster. The recommended second volume size is 512 MB
4. Click
Save.
59