Owner's Manual
3. From the NIC Type, select the NIC type:
• 2 Port
• 4 Port
4. Select the
Used for FC check box, if you want to use the NIC for Fibre Channel.
5. Under specific ports, if you want to partition the port, select the Do you want to partition? check
box.
6. Enter the following information for each ports or partitions:
a. Select the vLAN Networks to use for data transmission
b. Enter the Minimum Bandwidth and maximum bandwidth in percentage.
7. Repeat the steps 4 through 6 for each port.
8. After configuring interfaces, you can configure NIC Teams.
9. Click
Add.
Configuring Interface on Blade Servers
1. In the
Server Component dialog box, under Fabric Configuration, select Blade Server.
2. To enable the fabrics, select the corresponding check boxes next to
Fabric A, Fabric B, and Fabric C.
3. Under
Used for FC, select the check boxes next to Fabric B and Fabric C if you want to enable the
fabrics for Fibre Channel traffic.
4. From the
NIC Type, select one of following NIC types:
• 2 Port
• 4 Port
5. Under
<Port number>, if you want to partition the port, select the Do you want to partition? check
box.
6. Perform the following steps for each port and partitions:
a. In the
Network (vLAN) column, select the network that you want to configure on the port and
partition.
b. Enter the Minimum Bandwidth and Maximum Bandwidth in percentage.
7. Repeat the steps 4 through 6 for each port and partition.
8. Click
Add.
Importing From Reference Server
The
Importing From Reference Server feature enables you to import an existing server configuration and
use it for the new server component settings. You can edit the settings after importing the configuration.
To import a server configuration, perform the following steps:
1. On the
Server Component Settings page, click Import from Reference Server.
2. In the
Select Reference Server dialog box, click the server to import the configuration.
3. Click
Select.
Importing From Existing Template
The Importing From Existing Template feature enables you to import configuration from a server that is
part of an existing templates. You can edit the settings after importing the configuration.
40