Owner's Manual

Field Name Description
New volume name Enter the name of the volume that is to be created or destroyed. The
storage volume names created on same aggregate must be unique in a
NetApp storage array.
Storage Size e.g 100GB * Specifies the volume size. Enter the number of 512-byte blocks or the total
byte size. You can specify the total byte size in the following formats: MB
for megabytes, GB for gigabytes, or TB for terabytes. The volume size must
be between 20 MB and 999 TB.
Aggregate Name * Specifies the aggregate name on which the volume is created.
The space reservation
mode
Specifies the type of volume that guarantee the new volume will use.
Possible values:
none, File, Volume. If any value is not selected, the default
volume guarantee type is set to Volume.
The percentage of space to
reserve for snapshots *
Specifies the percentage of space to reserve the snapshots. Default value is
0.
Auto increment Select this check box to enable auto-increment of volume size. By default,
auto increment is enabled.
Persistent
• In Data ONTAP 7-Mode, the persistent is enabled by default. If it is
enabled, modifies the etc/exports file to append the rule for a
permanent change. (The new rule still takes effect immediately.)
• In Data ONTAP Cluster-Mode, the export entries are always persistent.
Persistent is enabled by default. If persistent is not enabled an error
occurs.
NFS Target IP Specifies the interface IP that is used for NFS traffic in your environment.
Server
To provision a bare metal server, add a server component in the template builder.
After selecting
Server on the template builder page, perform the following actions:
1. In the Server Component dialog box, from the Select a Component drop-down list, select a server
component.
2. In the # of Instances, box, enter the number of the server instances that you want to add.
3. Under Related Components, select the components that you want to map with the server
components. For more information about valid component combinations that can be mapped
together in a template, see
Component Combinations in Templates
4. Click Continue
.
5. To import an existing server configuration and use it for the server component settings, click Import
from Reference Server. On the Select Reference Server page, select the server from which you
want to import the settings, and click Select.
6. To import configuration from a server that is part of an existing templates, click Import from Existing
Template. On the Select Component page, select the server under a template, and click Select.
7.
Specify the settings to be configured on the server components.
37