Owner's Manual

Field Name Description

Thin Warning on Threshold

Specifies whether or not a thin provisioning sends an initiator warning

when passing the in-use warning threshold.

Thin Warning Hard

Threshold %

Specifies whether or not a thin provisioning allows the volume to remain

online after reaching the max-growth threshold.

Multi-host access of

volume

This parameter enables or disables multi-host access on a volume. The

possible values are

enable or disable.

Authentication Enables you to select one of the following authentication methods to

access the storage volume:

• CHAP

• IQN/IP

NOTE

: For VMware based deployment, you can use IP or Chap

authentication.

Chap username Specifies the CHAP username. A valid CHAP username must be less than or

equal to 63 alphanumeric characters. The access to CHAP username is

limited.

NOTE

: The Chap username and Chap secret fields are displayed only

if authentication type is selected as Chap.

Chap secret Specifies the CHAP password. A valid CHAP password must be less than or

equal to 254 characters. If the password is not specified, then it is

generated automatically.

Initiator IQN or IP

Addresses

Specifies the IQN or IP addresses that you want to configure on the

EqualLogic storage volume to enable access for the IPs or IQNs.

Enter the comma-separated list containing the IP addresses or IQN

addresses. The list should not contain a white space.

A valid IP address list must be in the format:

172.19.15.2,172.19.15.3,172.19.15.4

A valid IQN address list must be in the format: iqn.

2001-05.com.dellsoftware01,iqn.2001-05.com.dellsoftware02,iqn.

2001-05.com.dellsoftware01

Compellent Storage Settings

Target Compellent Device Specifies the compellent storage device where the volume is created.

Storage Volume Specifies the name of the volume that is to be created or destroyed.

Storage Size e.g 100g Specifies the volume size. Enter the number of 512-byte blocks or the total

byte size. To specify a total byte size, use k for kilobytes, m for megabytes,

g for gigabytes, or t for terabytes.

Boot Volume Specifies if the mapped volume is designated to be a boot volume.