Owner's Manual

• Make sure that the free servers are available in the server pool for migration, and it is compatible.

• During the migration, the operating systems will not be booted. Therefore, it is recommended to shut

down the server before migrating the boot from SAN image.

• It is recommended configure a server pool that has servers with same model, RAID, and networking

devices, including the specific slot to which network resources are connected.

Related Links

Migrating Servers

You can migrate only one server at a time. However, after a successful migration, additional servers can

be migrated. During migration, ASM will try to identify an exact match for the hardware. If it is not

available in the server pool, a different hardware can be selected.

You may encounter some issues during configuration of the new servers. In such scenarios, you can

address the issues preventing the proper configuration of the target server, and retry the deployment.

To migrate a server’s configuration to a different server pool:

1. In the

Service Details page, perform one of the following actions:

• In the topology view, click a server component, and click

Migrate in the box that is displayed

• In the topology view, click a server component, and click Migrate in the right page.

2. In the

Migrate Server(s) dialog box, in the State column, select the server, and then in the New

Server Pool column, select the designated server pool to migrate.

Adding Components to Existing Service Deployments

After a successful service deployment, you can add one or more server, storage, and VM components to

an existing service. However, you can only clone the existing component configuration in a service and

add a new component. You cannot create a component with a new configuration and add to a service.

NOTE

: You cannot add a component of a particular type if the component type is not a part of the

service reference template.

NOTE

: You cannot add components to a service for which deployment is in progress or to a failed

service deployment.

To add components to a service:

1. In the left pane, click

Services.

The Services page is displayed.

2. Select a service and click View Details in the right pane.

The Service Details page is displayed.