Owner's Manual

Field Name Description

Operating System Name Refers to the name of the operating system hosted on the server.

Server Object Folder Refers to the folder for the server.

Server WWN Values Refers to a globally unique world wide name for the requested HBA.

Port Type Refers to the transport type for all HBAs being added. This option is

required if the manual flag is set. The possible values are FibreChannel and

iSCSI.

Manual This parameter sets an optional flag to configure the requested HBAs

before the HBAs are discovered. If the WWN matches a known server port,

then this flag is ignored. If this flag is present, then the

porttype must also

be specified. The possible values are true or false.

Force Map If the value of this property is defined, it forces mapping, even if the

mapping already exists. The possible values are true or false.

Map Read Only Specifies whether or not a map is read-only. The possible values are true

or false.

Single Path Map Specifies that only a single local port can be used for mapping. If omitted,

all local ports are used for mapping. The possible values are true and false.

Configure SAN Switch Enables the zone configuration on the Brocade FC SAN switch.

Target Compellent Specifies the serial number of the Compellent Storage array that is targeted

for the deployment. You can select the serial number of Compellent

Storage array from the available discovered Compellent Storage arrays.

Switch

Currently, the switch component is not used in the Template Builder. Therefore, switch component is

greyed out. Network connectivity among components is specified within the settings for each

component.

Server

To provision a bare metal server, add a server component in the template builder.

After selecting Server on the template builder page, you can perform the following actions:

• Perform settings on the selected server instance properties that display on the right of the page (for

more information, see Server Settings).

NOTE: A Server name must be unique for a given deployment.

NOTE: The Select a Component drop-down list allows you to select a server instance and

perform settings on the selected server instance properties that populate on selecting a server

from Select a Component drop-down list.

• Select Related Components to be mapped with the selected server instance (refer to the Component

Combinations section in the Related Links below, to see the valid component combinations that can

be mapped together in a template).