User's Manual

Working with Orchestrations
Orchestration Management 13-5
2. Select a parameter in the Parameters pane.
3. Click Primary Sour
ce in Possible Values pane and select the value source for the selected parameter;
for example, select Software Repository.
4. Click Secondary Sour
ce in the Possible Values pane and select the Sub Type of the Value Source; for
example, select a particular type of Software Repository.
Note step 3 on page 13-5 and step 4 on page 13-5 is for advanced users or administrators. By default, the
Active System Manager software’s RA pre-populates the Primary Source and Secondary Source
entries, in most cases. However, step 3 on page 13-5 and step 4 on page 13-5 allow you to select
value from Primary Source and Secondary Source from a list of context-specific values.
5. Check the required parameter value from the list of values displayed to auto-populate the Value field
with selected value.
This value is referred to determine the actual runtime value of the parameter at execution time.
6. Click OK to add the custom operation in Orchestration.
Working with Orchestrations
The direct access to Template and Orchestration view is available through the Perspective navigation bar,
that appears on the extreme left of Active System Manager software.
Accessing the Orchestrations View
To access Orchestrations view through Perspective navigation bar, perform the following steps:
1. On the Active System Manager navigation bar menu, click the Template perspective; see Figure 13-3.