User's Manual

Managing Virtual Resources
12-72 Active System Manager User Guide, Release 7.1
2. In the Operation list that displays, select the resource to perform the operation.
One or more control resources display.
The list of parameters and operations will change depending on the resource Resource Adapter.
The Operation pull-down menu is pre-filled and a list of associated properties display.
3. Optional. Specify the following values for those properties:
• Name—By default is available by the Resource Adapter.
• Value—The default value (if available) displays.
• Mandatory—If true, then the value must be provided.
4. In the Execution Properties section, enter the number of times to run this operation. The default value
is 1.
5. Click the Execute Sequentially check box to enable it. If it is disabled (not checked), all executions are
performed in parallel.
6. Click OK.
Executing Monitoring Operations
Each resource type Resource Adapter may contain one or more operation definitions. Those operations can
be launched either from the Active System Manager system or from the Active System Manager portal.
To execute monitoring operations from the Active System Manager system, perform the following steps:
1. In the session editor, open a running session.
2. Right-click a resource and select Monitoring Methods > select a monitoring operation> and enter
optional parameters if required.
Executing Applications
Each resource type Resource Adapter may contain one or more application definitions. Those applications
can be launched either from the Active System Manager system or from the Active System Manager portal.
To execute applications from the Active System Manager system, perform the following steps:
1. In the session editor, open a running session.
2. Right-click a resource and select Applications > select an appropriate application> and enter optional
parameters if required.
Opening Resource Adapter Log
The Active System Manager application provides access to the Resource Adapter log on the Active System
Manager server, for each resource in a running session (or session).
To open the Resource Adapter log, perform the following steps:
1. In the Sessions view, open a running session.
2. Right-click a resource and select Resource Adapter Log > View.
The log displays in a file editor on the workspace; see Figure 12-60.