User's Manual

Working with Templates
11-42 Active System Manager User Guide, Release 7.1
Updating the Policy Sequencing
To update the policy sequencing, perform the following steps:
1. Select the policy impacted, and drag one or more resources or resource types in to the sequencing box.
A new sequence is automatically created (such as sequence1). You can add or remove resources or
resource types at will by either dragging back resources, or inserting new sequencing directly in the
sequencing box (right-click while operating elements).
2. Repeat step 1 for other policies (1 and 2).
Figure 11-20 Right-Click Menu Options
3. Click Reset to Default (see Figure 11-19) to re-apply the default policy (not the one saved).
4. Use the Filter text box to automatically filter out the resource or resource type list.
This is helpful when you need to search for a specific resource in your sequencing.
Note The timer cannot be defined between each sequence. Sequencing simply allows the policy
execution to happen in a sequential manner, as opposed to a parallel execution. Users do not have
any control on the results of those operations—all are executed independently of the prior sequence.
All operations are saved in the Session Audit report.
5. Click OK to save the changes, and then click File > Save to save the Template definition.
Quick Policy Status Check
To verify the policy status, perform the following steps:
1. Open the Template—Properties view and navigate to the Provisioning tab.
The policy group displays for each policy if the policy is set to Default or Defined (Figure 11-21).
2. Click Sequencing to update if necessary.