Solution Guide

Active System Manager Solution Guide—Active System 800 (AS800)
100
F Appendix F— Planning Worksheet
Table 18. Out of Band Management IP Address Configuration
Equipment
IP Address
Subnet Mask
Gateway
Username
Password
Chassis 1 CMC
Chassis 2 CMC
iDRAC for all M620
Force10 S4810 Switch1
Force10 S4810 Switch2
EqualLogic Storage Array
Group Management
EqualLogic Storage Array
Group on iSCSI Network
Active System Manager
Appliance
vCenter
F.1 ESXI Server IP Configuration
The following parameters for each server are required:
 ISCSIvNICIPAddresses—Space-separated list of IP addresses to be assigned to iSCSI virtual
network interface cards (vNICs). For example, for updating information for “vmnic6 vmnic7”
using the Update Port Group with iSCSI VLAN operation, the value will be in the
192.168.120.XX 192.168.120.YY format. The IP Addresses needs to be separated by a space
“ “
 ISCSINetmask – iSCSI subnet mask of the iSCSI virtual network interface cards (vNICs)
 iSCSIChapUsername – iSCSI Chap username used to access volume of EqualLogic Storage Array
 iSCSIChapSecret – iSCSI Chap secret corresponding to iSCSI Chap username.
 ServerHostname—Hostname to be assigned to the ESXi server.
 ServerDomainName – Domain name to be assigned to the ESXi server.
 ServerNameServer – Name server to be assigned to the ESXi server.
 ServerGateway—Gateway for the ESX server.
 ServerNetmask—Netmask for the ESX server.
 ServerIPAddress—IP address that must be assigned to the ESX server. If the hypervisor must
retrieve an IP address from the DHCP server, leave this parameter blank.
 ServerPassword – Server password to be assigned during unattended installation.