Users Guide

Options Description

Administrator password Enter the administrator password that set on the installed OS.

Confirm administrator password Enter to confirm the administrator password.

Select iSCSI Initiator Select one of the following:

• Hardware Initiator

• Software Initiator

NOTE: iSCSI Initiator is only supported with VMware.

Also, this option is supported only on the EqualLogic iSCSI

storage and Compellent iSCSI storage.

Install EqualLogic MEM If the value is True, install EqualLogic Multipathing Extension Module.

Product Key Specifies the product key to install the OS image on the server.

Timezone Specifies the time zone of the server.

NTP Server Specifies the IP address of the NTP server for time synchronization.

If you want to add more than one NTP server in the OS section of a

server component, make sure to separate the IP addresses using

comma (,).

Language Specifies the language to be displayed in the installed operating

system. That is, Windows operating system.

Keyboard Specifies the key board language to be used during Windows

installation.

Domain Name Specifies the domain name to which you want to add the host. For

example, aidev

FQ Domain Name Specifies the Fully Qualified Domain Name (FQDN) to which you want

to add the host. For example, aidev.com

Domain Admin Username Specifies the username to access the domain.

Domain Admin Password Specifies the admin password to add the host to the domain.

Domain Admin Password Confirm Enables you to reconfirm the admin password to add the host to the

domain.

Network Settings

NOTE: This setting is applicable for Server and Server (Hardware Only) components.

Add New Interface Click Add New Interface option to create a network interface in a

template server component. Under this interface all network settings

are specified for a server. This interface is used to find a compatible

server in inventory, for example if "Two Port, 10 gigabit" is added to

the template, when the template is deployed ASM will match a server

which has a two port 10-gigabit network card as it's first interface.

For more information on adding a new interface, seeAdding New

Interface.

Static Network Default Gateway Select the default gateway IP address for routing network traffic.