Users Guide

Field Name Description

Map Read Only Specifies whether a map is read-only. The possible values are true or false.

Single Path Map Specifies that only a single local port can be used for mapping. If omitted, all local ports are

used for mapping. The possible values are true and false.

Configure SAN Switch Enables the zone configuration on the Brocade FC SAN switch.

NetApp Storage Settings

Target NetApp Specifies the NetApp storage device where the volume is created.

Storage Volume Name Select the volume name on the NetApp array. To create a volume, from the Storage Volume

drop-down list, select Create New Volume.

New volume name Enter the name of the volume that is to be created or destroyed. The storage volume names

created on same aggregate must be unique in a NetApp storage array.

Storage Size e.g. 100 GB Specifies the volume size. Enter the number of 512-byte blocks or the total byte size. You can

specify the total byte size in the following formats: MB for megabytes, GB for gigabytes, or

TB for terabytes. The volume size must be between 20 MB and 999 TB.

Aggregate Name Specifies the aggregate name on which the volume is created.

Space reservation mode Specifies the type of volume that guarantees the new volume uses. Possible values: none,

File, Volume. If any value is not selected, the default volume guarantee type is set to Volume.

The percentage of space to

reserve for snapshots

Specifies the percentage of space to reserve the snapshots. Default value is 0.

Auto increment Select this check box to enable auto increment of volume size. By default, auto increment is

enabled.

Persistent

• In Data ONTAP 7-mode, the persistent is enabled by default. If it is enabled, modify the

etc/exports file to append the rule for a permanent change. (The new rule still takes

effect immediately.).

• In Data ONTAP Cluster-Mode, the export entries are always persistent. Persistent is

enabled by default. If persistent is not enabled an error occurs.

NFS Target IP Specifies the interface IP that is used for NFS traffic in your environment.

VNX Storage Settings

Target VNX

From the Target VNX drop-down menu, select the VNX that you want to deploy.

Pool Name

Select the target pool name from the Pool Name drop-down menu.

Storage Volume Name

Select the storage volume name from the Storage Volume Name drop-down menu.

New Volume Name To create a volume, from the Storage Volume Name drop-down menu, select Create New

Volume.

Configure SAN Switch Enables the zone configuration on the Brocade FC SAN switch.

Storage Size e.g. 100 GB

Specify the volume size.

Type

List the LUN types that are supported by storage. Non Thin is the default option.