Install Guide

Conguring DHCP or PXE on External Servers

The PXE service requires a DHCP server congured to provide boot server (TFTP PXE server) information and specic start-up le

information. ASM PXE implementation uses the iPXE specication so that the conguration details include instructions to allow

legacy PXE servers and resources to boot properly to this iPXE implementation.

This section provides information about conguring DHCP on the following servers. The information includes only the basic

conguration options and declarations required for an iPXE environment. These details should be used as a cumulative addition to

the settings currently used in your DHCP implementation (if you already have a DHCP environment).

• Microsoft Windows 2012 Server. See Congure DHCP on Windows 2012 DHCP Server

• Microsoft Windows 2008 Server R2. See Congure DHCP on Windows 2008 DHCP Server

• Linux DHCPd (ISC DHCP). See Conguring DHCP for Linux

NOTE: Ensure that your DHCP scope has enough IP addresses. The installation process can temporarily consume

between 4-8 IPs during the initial PXE boot process. This is based on interface card conguration and the number of

physical interfaces on the server. These IPs only used temporarily during server conguration and installation.

Congure DHCP on Windows 2012 DHCP Server

To congure the DHCP on Windows 2012 DHCP Server, perform the following tasks:

1. Create DHCP User Class

2. Create DHCP Policy

3. Create Boot File scope option

For additional information, see http://ipxe.org/howto/msdhcp

Creating the DHCP User Class

You must create the user class for the DHCP server before creating the DHCP Policy.

1. Open the Windows 2012 DHCP Server DHCP Manager.

2. In the console tree, navigate to IPv4. Right-click IPv4, and then click Dene User Classes from the drop-down menu.

3. In the DHCP User Classes dialog box, click Add.

4. In the New Class dialog box, type the following information and click OK to create a user class.

a. In the Display Name box, type iPXE.

NOTE: The binary for the output of the ASCII “iPXE” is (69 50 58 45).

b. In the Description box, enter iPXE Clients.

c. In the data pane, under ASCII, enter iPXE.

5. Click Close.

Creating the DHCP Policy

1. Open the Windows 2012 DHCP Server DHCP Manager.

2. In the console tree, expand the scope that services your ASM OS Installation network. Right-click Policies and select New

Policy.