Release Notes

• Issue: ASM-1894 : ASM is unable to distinguish volumes with the same names in different
Compellent folders.
Description : ASM cannot distinguish volumes with a same name in different
folder in a Compellent inventory
Resolution/Workaround : Ensure that you provide unique names for volumes
used by ASM in your Compellent inventory.
• Issue: ASM-2144 : Server with bare hard drive fails to get HddSeq set properly
Description : If you choose SD boot and the server has a bare hard drive (not
connected through a RAID controller) the HddSeq may fail to get set properly,
Leaving the bare hard drive at the top of the list. The server may boot off the
bare hard drive instead of the SD card where the operating system was
installed.
Resolution/Workaround : None
• Issue: ASM-2287 : The server teardown operation does not remove the Active Directory
and DNS entries of the servers.
Description : If you tear down servers in a service, Active Directory and DNS
entries of the server are not removed if the associated cluster is not selected
for tear down. In addition, in some cases, if ASM is unable to communicate
with the Active Directory or DNS server, these entries may also not be
removed.
Resolution/Workaround: To remove the Active Directory and DNS entries of
the server, make sure to select the associated cluster. If the issues persist,
confirm that the Active Directory and DNS entries have been removed from
the server manually.
• Issue: ASM-2599 : Issue with Configure Resources when IOM Firmware is out-of-date with
minimum firmware requirements.
Description : The following error message is displayed while configuring
resources when a firmware running on the I/O module does not meet the
minimum requirements. If the IOM firmware is not within the Compatibility
Matrix minimum firmware, The following error is displayed when it attempts
to show the discovered resources.
An Unexpected error has occurred on the system Please try
again later.
Resolution/Workaround : You must update the I/O module firmware and
retry initial discovery and configuration of the chassis.
• Issue: ASM-2951 : Error message is displayed during firmware update on C series.
Description : While performing firmware update on C series servers, the
health status of the C series switch changes to <gray> and the following error
message is displayed.
Unknown error querying ipmi on host 172.31.32.142: Could
not retrieve IPMI status: ipmi_sensor_read: internal IPMI
error.
Resolution/Workaround: This is an expected behavior because connection is
not established with the BMC for a few seconds when you initiate firmware
update operation, and the firmware update continues after the connectivity is
established with BMC.
• Issue: ASM-3133 : ASM performs the discovery operation on the FX2 chassis after you
update the CMC firmware.
Description : The Chassis firmware update will trigger the Chassis inventory
which will trigger the Chassis discovery in order to detect any newly inserted
blades or IOMs.