Users Guide

j. Enter the Domain Name and FQ Domain Name to which you want to add the Hyper-V host.
k. Enter the Domain Admin Username and Domain Admin Password to add the Hyper-V host to
the domain. Enter the domain admin password again to confirm.
NOTE: It is critical to update the password within this template. There is a masked value
present in the template, but there is no actual password set. If you do not set this
password, you will not be able to log in to the deployed server.
l. Under Network Settings, perform the following:
1. Clear the Do you want to partition? check box.
NOTE: For a Hyper-V deployment, partitions are not required.
2. Update the network settings based on the hypervisor that you want to deploy and the
networks that you have configured in your environment. Select at least one PXE Network,
Hypervisor Management Network, Hypervisor Migration Network, Hypervisor Cluster
Private Network, and an optional Public network for virtual machines.
6. Click Save.
7. On the Template Builder page, click the Hyper-V Cluster component, click Edit in the dialog box
that is displayed, and then configure the following settings in the
Cluster Component dialog box:
a. From the Hypervisor Management Software drop-down list, make sure that you select your
target SCVMM.
b. From the Host Group drop-down list, select an existing host group, or in the New host group
name box and enter the name of the host group that you want to create.
c. From the Cluster Name drop-down list, select New Cluster and then in the New cluster name
box, enter an updated name for the cluster that will be created in SCVMM.
8. Click Save.
9. Click Publish Template.
This template is now ready to be deployed.
Template – deploy VMware cluster with NetApp storage
The Deploy VMWare Cluster with NetApp Storage template deploys a single NetApp storage volume,
installs ESXi on two physical hosts, and creates a cluster with the ESXi hosts.
To deploy VMware Cluster with NetaApp Storage using this template, perform the following steps:
1. On the Templates page, select the VMware Cluster with NetApp Storage template, and click Clone
in the right pane.
2. In the Create Template dialog box, enter a name, category, and description for the template, and
click Save.
3. On the Template Builder page, click each storage components, click Edit on the dialog box that is
displayed, and then configure the following settings in the Storage Component dialog box:.
a. Modify the Component Name with a unique name, as desired.
b. From the Target NetApp drop-down list, select the target NetApp Storage.
c. Modify the Storage Volume Name and Storage Size, as desired.
d. From the Aggregate Name, select the aggregate name that is used in your NetApp storage.
e. From the NFS Target IP, select the target NFS IP that will be used.
4. Click Save.
74