Users Guide

• Management IP — Displays the management IP address of the server.
2. If you want to modify the iDRAC DNS Name of the server, in the iDRAC DNS Name column, enter an
iDRAC DNS name for the server.
3. To configure the IO modules within the chassis, click Next.
Configuring unique I/O module settings
1. On the Unique I/O Module Settings page, select Configure Unique I/O Module Settings check box
to modify the unique settings for the IO modules with in the chassis.
The Unique I/O Module Settings page lists the I/O modules within the chassis that you have
selected. Each section in this page lists the I/O modules within a chassis. Click the arrow left to the
section to expand or collapse the section.
The page displays the following information about the I/O modules that have been discovered:
• Service Tag — Displays the service tag of the I/O module. The service tag is a unique identifier
provided by the manufacturer for support and maintenance.
• Fabric Slot — Indicates the slot name where the I/O module is present.
• Management IP — Displays the management IP address of the server.
• Host Name — Displays the host name of the I/O module.
2. If you want to modify the host name of the I/O module, in the Host Name column, enter the host
name for the corresponding I/O modules.
3. To configure the uplink ports, click Finish.
I/O Module Configuration
Use this page to configure uplinks on the MXL Switches and IOAs within one or more chassis.
NOTE: ASM supports configuration of uplinks on MXL Switches and IOAs. It supports VLT workload
network configuration too.
NOTE: MXL is a 10Gb/40Gb Ethernet blade switch used in our M1000E chassis. During the ASM
onboarding process we can configure management IP address, credentials, basic management
settings, and configure an uplink to the top of rack networking device for the chassis.
An I/O module is a switch for a blade chassis.
From this page, you can:
• Define the uplinks. For more information, see Defining Uplinks.
• Upload switch configuration file. For more information, see Upload Switch Configuration File
• Enable VLT. For more information, see VLT Enabled
• Configure the uplinks in one of the following ways:
– Configure the same ports as uplink ports in all the chassis. See Configure the uplink ports
differently in all the chassis
– Configure the uplink ports differently in all the chassis. See ConfigureChassis: Configuring Uplink
Ports on Each I/O Module Independently
110