Users Guide

Adding or editing Integrated Dell Remote Access Controller (iDRAC) user
1. On the Create Local User page, enter User Name of an account.
2. Enter the Password for the user account to log in to iDRAC. Reenter the password for confirmation.
3. Select one of the following Role to assign to user account:
• User
• Operator
• Administrator
• No Access
4. To enable this user account, select Enable User check box. Clear the Enable User check box to add
the user in a disabled state.
Removing resources
NOTE: On the user with Administrator role can remove the resource from ASM.
To remove any particular resource from ASM, perform the following steps:
1. In the left pane, click Resources.
2. On the Resources page, click the All Resources tab.
3. From the list of resources, select one or more resources, and click Remove.
4. Click OK when the confirmation message is displayed.
If you remove a Chassis, the Chassis and associated servers and I/O modules are removed from ASM. The
removal process shuts down the servers and erases identity information to prevent potential corruption,
and identity information returns to the associated pool. Associated targets (for example, storage volume)
are not affected.
NOTE: You cannot remove a chassis that is in any Pending state.
If you remove a server, the server state changes to Pending. The server powers off, ASM erases network
identity information from the server to prevent potential corruption, and network identity information
returns to the associated pool.
Updating resource inventory
NOTE: Only the user with Administrator or Standard role can run the inventory on the resources.
However, Standard user can only run the inventory on the resources that are part of server pool for
which they have permission.
To manually run the inventory operation and update ASM with the latest resource data:
1. In the left pane, click Resources.
2. On the Resources page, click the All Resources tab.
3. From the list of resources, click a resource, and in the Details pane, click Run Inventory.
When you select C- series server on resource page and click Run inventory, you will not get all the
inventory details for C 622O server. You will only get basic information about it. After you deploy the
server, you will get detail information about this.
105