Users Guide

5. In the Chassis Configuration page, select one or more chassis to configure the following global

settings, and then click Next. For more information, see Configure Global Chassis Configuration

Settings.

a. Under Users, configure additional CMC and iDRAC local users.

b. Under Monitoring, change the default monitoring settings.

c. Under NTP, select the time zone and NTP servers.

d. Under Power Config, configure power budget and redundancy attributes.

e. Under Networking, add networking settings for the chassis.

6. On the Unique Chassis Settings page, configure specific chassis settings on chassis individually, and

then click Next. For more information, see Configuring Unique Chassis Settings.

7. On the Unique Server Settings page, enter the iDRAC DNS name for the servers within the chassis,

and then click Next. For more information, see Configuring Unique Server Settings.

8. On the Unique IO Module Settings page, enter a host name for each I/O module on chassis, and

then click

Next. For more information, see Configuring Unique I/O Module Settings.

9. On the Uplink Port Configuration page, configure uplinks ports on the MXL switches with in the

chassis, and then click Next. For more information, see Configuring Uplink Ports

10. On the Summary page, verify the chassis configuration settings and click Finish to configure the

chassis.

Related Tasks

Removing discovered resources

Configuring default firmware repository

Running firmware compliance

Configuring global chassis settings

Configuring unique chassis settings

Configuring unique I/O module settings

I/O Module Configuration

Completing the chassis configuration

Removing discovered resources

The Discovered Resources page list the resources discovered in ASM.

On this page, you can select one or more resource that you do not want to be in ASM environment, and

click Remove Resource from ASM.

When you performing next configuration steps using Configure Resource dialog, ASM enables you to:

• Create a default firmware repository

• Perform a firmware compliance check on these resources against the firmware level specified in the

default repository.

• Allows you to update the firmware as needed.

• Configure one or all chassis that have been discovered.

Configuring default firmware repository

On the Default Firmware Repository page, you can:

• Click Add Repository to create new firmware repositories.

• Click Remove to remove a repository