Users Guide

3. Type the credential name and user name which you need to log into the application.

4. Type the domain name in the Domain Name field which is an optional entry

5. Type the password and Confirm Password in the Confirm Password field.

6. Go to Resources Discover and click on the Discover tab.

7. Select Element Manger from the Resource Manager drop-down.

8. Type the IP Address in the Starting IP Address field for the Element Manager.

9. Select Element Manager from the Element Manager drop-down credentials.

10. The Element Manager will get discovered

11. In the Details area on the right side, the run inventory details are not displayed as the support will be

provided in detail later.

Configuring resources or chassis

Use the Configure Chassis wizard to perform the following operations:

• Remove one or more resource from ASM environment. You can perform this operation only when

you launch this wizard from Getting Started page.

• Enables you create your own custom firmware repository, import firmware repository from Dell

Repository Manager (DRM), and perform firmware compliance check on the resources. You can

perform this operation only when you launch this wizard from Getting Started page

• Enables you to on board or reconfigure one or more chassis and servers and I/O modules within the

chassis.

NOTE:

When you configure the chassis and iDrac users, the existing user account on the Chassis and

iDrac will be erased and replaced by the new user settings that is entered on the Chassis

Configuration Wizard.

Before you begin, it is recommended to gather the following information:

• User names and passwords of accounts that can access the resources.

• Optionally, SMTP server and email address for an account to receive alerts.

• Optionally, NTP server IP addresses

• (Optional) Chassis Management Controller (CMC) and Integrated Dell Remote Access Controller

(iDRAC) VLAN IDs.

1. On the Welcome screen, read the instructions, and click Next.

2. The Discovered Resources page lists the resources discovered in ASM. If you do not want one or

more resources to be in ASM environment, select the resources, and click Remove Resource from

ASM

. Click Next.

NOTE: The Discovered Resources, Default Firmware Repository, and Firmware Compliance

pages are displayed only when you start this wizard from the Getting Started page.

3. On the Default Firmware Repository page, create and import your own custom repositories from

DRM to use as the default firmware level for your discovered resources. Click Next.

The Firmware Compliance page lists the resources that do not meet the firmware requirements

specified by the default repository.

4. On the Firmware Compliance page, select the resources to update the firmware running on the

resources automatically to meet the firmware requirements specified in the default repository. Click

Next.