Setup Guide

NOTE:

• If any additional drivers are required, add the drivers under the “Drivers” folder in the build

directory you created on your ADK machine. The drivers are installed into the Windows

image, if applicable. The drivers that do not apply to the OS being processed are ignored.

• If you want deploy Windows to VMWare VMs, the WinPE drivers for the VMXNET3 virtual

network adapter from VMWare required. To obtain the VMware Windows drivers: Install

VMware tools on a running Windows 2012 or Windows 2012 R2 and on the virtual machine.

Go to the C:\Program Files\Common Files\VMware\Drivers directory. Copy the contents in

the Drivers folder to the directory that contains your WinPE build scripts.

• If you deploy Windows 2012 or 2012 R2 to an M420 server, drivers for Broadcom network

adapters must be added to the image, as they are not included in Windows. Obtain a copy

of the Broadcom Drivers for an m420 server from dell.com and install the driver package on

a Windows 2012 or 2012 R2 machine. Locate the Windows drivers on the files system and

copy them to the “Drivers” folder. These drivers typically start with "b57".

• Native driver support for Dell server components in Windows 2008 R2 is limited, so obtain

the latest NIC and RAID drivers for Windows 2008 R2 from Dell.com

3. Log in to the ASM virtual appliance and obtain the script “build-razor-winpe.ps1” from the /opt/razor-

server/build-winpe directory and copy this to the build directory created in step 1 on your machine

with ADK 8.1.1 or 8.1.1 installed in the default location.

4. The build-razor-winpe script supports and ASM appliance that uses an external DHCP/PXE server, or

using the ASM appliance as your DHCP PXE server. This command to run this script has the following

structure:

powershell -executionpolicy bypass -file build-razor-winpe.ps1 [ASM

appliance IP or “DHCP”] [Your Windows .iso name] [New Windows .iso name]

If ASM does not act as the DHCP/PXE server, that is your DHCP/PXE server is external, you will run

the script and provide the ASM appliance IP as input.

For example,

powershell winpe.ps1 192.168.1.1 Windows2012r2.iso ASMWindows2012r2.iso

If ASM acts as the DHCP/PXE server you will run the script and provide the input “DHCP” instead of

the ASM appliance IP.

For example:

powershell winpe.ps1 DHCP Windows2012r2.iso ASMWindows2012r2.iso

NOTE: This step takes some time to complete. After completion, it creates a new Windows .iso

file which is customized for using with ASM. You must go to repositories and upload .iso file.

NOTE: If the build script fails or is stopped during execution it may be necessary to clean up

files in the build directory before executing again. In some cases, directories may still be

mounted and require cleanup. To clean up, delete all files other than the necessary script,

starting .iso, and Drivers folder. If any files cannot be deleted, try executing the following

commands from a command prompt in the build folder location:C:\buildpe>dism /

cleanup-wim

Adding OS Image Repositories

You can add one or more OS image repositories in ASM GUI.