Release Notes
•
Issue: ASM-4593
: Dell PowerEdge FC830 and PowerEdge R930 servers fail on vm during
hyper-v deployment.
o
Description
: Server reboots automatically when creating VM on HyperV
server. This happens on Dell Server when Node Interleave is enabled in the
server BIOS.
o
Resolution/Workaround
: Disable Node-Interleave in the server BIOS.
•
Issue: ASM-4632
: Not able to create a deployment with FX2 servers having Quad Port Card
in Integrated Slot and FC Card in Chassis Slot 8.
o
Description
: In the template specify Quad Port 10GB in fabric A and FC in
Fabric B. While deploying the template a Network configuration mis-match
error is displayed.
o
Resolution/Workaround
: If users use PCIe cards, you need to follow the
mapping provided below to expect the template to define the fabrics:
Fabric B Fabric C
Server slot 1 – PCIe slot 7 PCIe slot 8
Server slot 2 – PCIe slot 3 PCIe slot 4
Server slot 3 – PCIe slot 5 PCIe slot 6
Server slot 4 – PCIe slot 1 PCIe slot 2
•
Issue: ASM-4688
: In NIC firmware, the X520/I350 rNDC firmware version 15.0.28 to
version 16.5.20 firmware fails to update in the firmware update logs.
o
Description
: This is due to a specific firmware update issue with the
X520/I350 rNDC firmware version 16.5.20. The X520/I350 rNDC firmware
may require a step-up to an intermediate version of the firmware in order to
upgrade from 15.0.28 to 16.5.20.
The problem might be due to the catalog problem where ASM is trying to
apply the wrong firmware.
Resolution/Workaround
: None
•
Issue: ASM-4697:
Logs messages need to be updated for firmware retry logic.
o
Description
: Firmware updates retries up to three attempts displaying an
error message for each failed attempt. The message displayed must be
updated to indicate a failed attempt occurred and a retry will follow. In some
cases a success message is logged followed by an error message.
o
Resolution/Workaround
: None
•
Issue: ASM-4775
: Broadcom NIC will fail firmware update if current firmware is older than
7.8.53.
o
Description
: Broadcom firmware in the ASM catalog, 7.10.18, will require a
minimum of 7.8.53 for the firmware update to succeed.
Resolution/Workaround
: None
•
Issue: ASM-4908
: Domain name lookup from the ASM interface continues to fail even after
configuring DNS on the appliance.
o
Description
:
If the DNS is not configured during initial setup, the domain
name lookup fails and this negative lookup is cached in the system.
Subsequent domain name lookup attempts continue to fail even after
configuring DNS on the appliance.
Resolution/Workaround
: It is recommended to configure DNS during initial
setup. If DNS is configured after the domain lookup fails, restart the appliance
to resolve the issue.