Users Guide

• Select the Configure the uplinks on each I/O Module Independently check box to configure

different ports as uplink ports in each I/O module.

The table lists ports that are available in each I/O module in separate columns.

• Clear the Configure the uplinks on each I/O Module Independently check box to configure the

same ports as uplink ports across all I/O modules.

The table displays the following information:

– IO modules (Model Name) that is present in each fabric.

– Ports that are available in each IO module.

4. In the table, select the Quadport mode check box if you want to run the port in Quad mode.

When a 40 GbE port is run in quad mode, it provides four 10 GB Ethernet interfaces that number

sequentially starting with the port number of the 40GbE interface. For example, when Quadport

mode is enabled on the GbE port number 33, it makes four 10GbE links with the port numbers 33,

34, 35, and 36.

5. From the drop-down list next to the corresponding port numbers, select the uplink that you want to

configure on each port.

6. Click Next.

Completing the chassis configuration

1. On the Summary page, click Finish to apply the configuration on the chassis you have selected.

In the Resources → All Resources tab, the state of the chassis are displayed as Updating until the

configuration is complete.

2. If you want modify the chassis configuration settings, click Back.

Adding or editing Chassis Management Controller (CMC) user

1. On the Create Local User page, enter User Name of an account.

2. Enter the Password for the user account to log in to CMC. Reenter the password for confirmation.

3. Select one of the following Role to assign to user account:

• Administrator

• Power User

• Guest User

• None

4. To enable this user account, select Enable User check box. Clear the Enable User check box to add

the user in a disabled state.

Adding or editing Integrated Dell Remote Access Controller (iDRAC) user

1. On the Create Local User page, enter User Name of an account.

2. Enter the Password for the user account to log in to iDRAC. Reenter the password for confirmation.

3. Select one of the following Role to assign to user account:

• User

• Operator

• Administrator