Users Guide

Configuring unique chassis settings
Configuring unique I/O module settings
Configuring uplink ports
Completing the chassis configuration
Removing discovered resources
The Discovered Resources page list the resources discovered in ASM.
On this page, you can select one or more resource that you do not want to be in ASM environment, and
click Remove Resource from ASM.
When you performing next configuration steps using Configure Resource dialog, ASM enables you to:
• Create a default firmware repository
• Perform a firmware compliance check on these resources against the firmware level specified in the
default repository.
• Allows you to update the firmware as needed.
• Configure one or all chassis that have been discovered.
Configuring default firmware repository
On the Default Firmware Repository page, you can:
• Click Add Repository to create new firmware repositories.
• Click Remove to remove a repository
• Click View Details to view the firmware bundles that are available in the firmware repository.
• Select a repository from the list and click Set as Default to set the repository as default firmware
repository.
Running firmware compliance
ASM requires a minimum firmware level for all resources it manages.
The Firmware Compliance page list the resources that do not meet the firmware requirements specified
in the default repository that you have set in the previous step.
On this page, select the resources that you want to update the firmware automatically, click Next.
If you skip the automatic firmware update, in the Resources → Resources tab, the Firmware Compliance
state of the resources that is not compliant is displayed as either Update Required or Non-Compliant .
Configuring global chassis settings
1. On the Chassis Configuration page of the Configure Chassis wizard, select one or more chassis that
you want to configure.
2. Under Select Chassis for Initial Configuration, select the one or more chassis that you want to
configure.
3. Under Global Settings, in the Users section, configure additional CMC and iDRAC local users.
a. To add new Chassis Management Controller (CMC) user, under CMC Users, click Create. For
more information, see Adding or Editing a Chassis Management Controller (CMC) User.
84