Users Guide

NOTE: It is critical to update the password within this template. The value in the
template is masked, but the actual password is not set. If this password is not set, you
cannot log in to the deployed server.
2. Retain the ESXi value as default in the OS Image Type drop-down list.
3. From the OS Image drop-down list, select an OS for a hypervisor (Example: ESXi 5.1 or ESX
5.5) that are configured and to be deployed within your ASM managed environment.
d. Under Network Settings section, update the network settings accordingly for the hypervisor
that you are deploying and for the configured networks in your environment.
5. On the Template Builder page, click the cluster component, click Edit in the box that is displayed,
and then configure the following settings in the Cluster Component dialog box. Repeat this step for
each cluster components.
a. In the Component Name text box, type the component name. (Optional)
b. Under Cluster Settings, configure the following:
1. From the Target Hypervisor drop-down list, select the target vCenter.
2. In the Data Center Name and Cluster Name text boxes, type their corresponding names.
6. On the Template Builder page, click the virtual machine component, click Edit in the box that is
displayed, and then configure the following settings in the Cluster Component dialog box. Repeat
this step for each cluster components.
a. Enter the Administrator password.
b. From the OS Image drop-down list, select the Windows Image to deploy Windows on the virtual
machine.
c. Select the Workload check box next to the Networks field if you want workload networks to
access this VM.
NOTE: Make sure that the same workload network that you have selected was selected for
both of the servers in the Template Builder.
7. On the Template Builder page, click the application component, click Edit in the box that is
displayed, and then configure the following settings in the Application Component dialog box.
Repeat this step for each application components.
a. In the Source Location box, enter the directory location where the Citrix XenDesktop7 ISO was
unpacked. You should enter the directory location for each of the application components.
The location for the directory is //<ASM appliance IP>razor/XenDesktop7/x64/XenDesktop
Setup.
8. To save the settings, click Save.
9. To publish the template, click Publish Template.
The template is now ready to be deployed.
Template – deploy operating system to hard drive
This template deploys an OS to the local hard disk drive of a bare metal server. A single server component
is available in the Template Builder.
1. In the Templates page, select the Deploy OS to Hard Drive template, and then click Clone in the
right pane.
2. In the Create Template dialog box, enter the Template Name and Template Description.
3. Click Save.
56