Users Guide

Switch Deployment Status Description Requires
Action
Recommended Actions
UPLINK RECONFIGURED
REDEPLOY REQUIRED
Uplink re-configured,
Re-deployment of
Switch is required
Yes Restart switch deployment.
NOTE: Verify that the switch
is not in BMP mode.
1. Navigate to the Network >
Fabric Name > Configure and
Deploy screen.
2. From the Deploy Fabric
drop-down menu, select
Deploy and Validate.
3. On the Deploy tab, select the
switch and click Deploy
Selected.
REDEPLOYMENT
REQUIRED
Re-deployment of the
switch is required
Yes Restart switch deployment.
NOTE: Verify that the switch
is not in BMP mode.
1. Navigate to the Network >
Fabric Name > Configure and
Deploy screen.
2. From the Deploy Fabric
drop-down menu, select
Deploy and Validate.
3. On the Deploy tab, select the
switch and click Deploy
Selected.
Deployment Task Errors
AFM
Deployment
Task
Error Status Recommended Action
Verify switch
eligibility
Eligibility check for
deployment: Failed
Verify that the VLT switch deployment has a management
IP for all peers.
Ping verification Ping verification: Failed Verify that the DHCP offer was received on the device
console. Power cycle if needed.
Telnet/SSH
connectivity
verification
Telnet/SSH session
verification: Failed
Verify Telnet/SSH connection and that the DHCP offer was
received on the device console. Power cycle if needed.
Reset to factory
defaults
Reset to factory defaults
task: Failed
Verify Telnet/SSH connectivity and redeploy.
Minimal
configuration
upload to switch
Minimal config upload:
Failed
Verify Telnet/SSH connectivity and redeploy.
Minimal config upload
on Unit-1: Failed
Verify Telnet/SSH connectivity and redeploy.
Troubleshooting
171