Users Guide

NOTE: If you are using Internet Explorer and the Windows 7 OS, change your indexing options by
performing the following steps:
1. Navigate to the Control Panel >Indexing Options screen.
2. Click Advanced and then click the File Types tab.
3. In the Add new extension to list field, enter conf as the extension file type and then click Add.
4. Click OK.
1. Navigate to the Network > >Fabric Name> Configure and Deploy screen.
2. From the Deploy Fabric drop-down menu, select View DHCP Configuration .
3. From the Deploy drop-down menu, select View DHCP Configuration. For more information about
DHCP, refer to DHCP Integration.
Deploying and Validating the Fabric
Deploying the Fabric
To deploy the fabric, use the Network > Fabric Name> Configure and Deploy > Deploy Fabric > Deploy
and Validate screen. When you deploy a fabric, make sure that the fabric design matches the deployed
fabric. AFM prompts you to fix any errors when you deploy the fabric.
Figure 69. Configure and Deploy — Deploy and Validate
NOTE: During initial deployment, the BMP process wait time to install the software onto the
switches in the fabric depends on whether stacking is enabled. Approximate wait times are:
• 10 minutes for a non-stacked fabric
• 20 minutes for stacked fabric
To view a custom configuration file, navigate to the Network > Fabric Name> Configure and Deploy
screen. From the CLI Configuration drop-down menu, select the Custom Configuration option.
Use the following Deployment Status table to troubleshoot deployment issues.
134
Configuring and Deploying the Fabric