Users Guide

NOTE:
Before deployment, make sure that the IOA switches are in standalone mode using the
following CLI command:
show system stack-unit <unit-number> iom-mode
For more information about this command, refer to the Dell PowerEdge Command Line
Reference Guide for the M I/O Aggregator.
2. During deployment, check for IOA deployment failures such as Not being in Standalone Mode in the
Response Actions column. To correct this issue, set the IOA to standalone mode and then redeploy
it. For information about IOA pre-deployment error messages, see IOA Pre-deployment Error
Messages.
Figure 47. Deploy and Validation Tabs
IOA Pre-deployment Error Messages
Use the following table to troubleshoot the IOA pre-deployment.
Error Recommended Action
Discovered MAC is different from planned
MAC
Make sure the MAC provided for this device is correct.
Discovered model is different from
planned model
Make sure the model provided for this device is correct.
IOA is not in standalone mode Make sure the IOA is in standalone mode.
IOA Software Upgrade task: Failed
1. Power cycle the IOA.
106
Configuring and Deploying the Fabric