OpenStack Guide

netmask 255.255.255.0

bond-mode 802.3ad

bond-miimon 100

bond-lacp-rate 1

bond-slaves none

4. Restart the network service by rebooting the compute node at /etc/init.d/networking restart

5. After the reboot is complete, verify the bonding interface by checking the /proc/net/bonding/ directory

The following example shows how to check the bond0 interface. In this example, the bonding mode and the slave

interface

eth4 and eth5 have a MII Status of Up.

root@dev1-openstack03:/etc/network# cat /proc/net/bonding/bond0

Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: IEEE 802.3ad Dynamic link aggregation

Transmit Hash Policy: layer2 (0)

MII Status: up

MII Polling Interval (ms): 100

Up Delay (ms): 0

Down Delay (ms): 0

802.3ad info

LACP rate: fast

Min links: 0

Aggregator selection policy (ad_select): stable

Active Aggregator Info:

Aggregator ID: 1

Number of ports: 1

Actor Key: 33

Partner Key: 1

Partner Mac Address: 00:00:00:00:00:00

Slave Interface: eth4

MII Status: up

Speed: 10000 Mbps

Duplex: full

Link Failure Count: 28

Permanent HW addr: 00:10:18:d0:3d:60

Aggregator ID: 1

Slave queue ID: 0

Slave Interface: eth5

MII Status: up

Speed: 10000 Mbps

Duplex: full

Link Failure Count: 28