Users Guide

4. Pre-Deployment — SNMP and CLI Credentials

5. Pre-Deployment — Software Images

6. Pre-Deployment — DHCP Integration

7. Pre-Deployment — Summary

Layer 3 with Resiliency (Routed VLT) Pre-Deployment

To prepare the Layer 3 with Resiliency (Routed VLT) fabric for deployment, complete the following tasks

using the Pre-deployment Configuration wizard.

1. Protocol Configuration for Layer 3 fabric:

• Pre-Deployment L3 Routed VLT — Fabric Link Configuration

• Pre-Deployment L3 Routed VLT — Uplink Configuration

• Pre-Deployment L3 Routed VLT — VLAN Configuration

• Pre-Deployment L3 Routed VLT — Port Channel Configuration

• Pre-Deployment L3 Routed VLT — VLAN Mapping

2. Pre-Deployment — Assign Switch Identities

3. Pre-Deployment — Management IP

4. Pre-Deployment — SNMP and CLI Credentials

5. Pre-Deployment — Software Images

6. Pre-Deployment — DHCP Integration

7. Pre-Deployment — Summary

Device MAC Association

NOTE: Device MAC association does not support S55 or S60.

To automatically discover MAC addresses for devices, use the Device MAC Association screen. In the

Pre-deployment wizard, you must manually enter the MAC address of each device. After using Device

MAC Association, AFM lists the applicable MAC addresses for each device in the fabric for your selection.

In previous versions of AFM, the MAC address for each device in the fabric had to manually load in the

Pre-Deployment wizard. If a .csv file was used, each MAC address had to be manually matched with the

correct device. Device MAC Association automatically discovers MAC addresses for devices in the fabric.

If you use Device MAC Association, you do not need to upload a .csv file or enter the MAC addresses

manually.

Configuring and Deploying the Fabric