Users Guide

The Edit Switch Unit dialog box appears.
NOTE: Depending on pre-deployment/deployment status, some options cannot be changed.
Refer to Operations Allowed.
3. To save changes, click OK.
Removing Access Switches
1. In the Add Switch Unit dialog box, select a configured switch.
2. In the upper left of the Advanced Access Config screen, click Delete.
3. To confirm the switch deletion, click Yes.
Advanced Fabric Design — Port Configuration
On the Advanced Port Config screen of the Fabric Design wizard, you can configure the proposed port
numbers for uplinks, stack ports, inter chassis (VLTi and MLAG) links, and fabric links. To export the data,
click
Export.
NOTE: Configure only one source port number for each switch.
Figure 31. Advanced Port Config
1. From the Switch drop-down menu, select a switch.
2. For each device, from the From Port drop-down menu, select a port.
NOTE:
• To reset a switch to previous port configurations, select it and then click Reset Switch.
• To reset all switches to previous port configurations, click Reset All Switches.
• To reset a switch to default settings, select it and click Reset to default.
• For switches that are not pre-deployed, the drop-down menus display both used and
available ports. For pre-deployed switches, only available ports appear.
• If you change aggregation or access information, AFM resets port configurations.
• If you change port information for either of the VLT or MLAG switches, AFM updates the
port configuration in the other switch in the pair to maintain symmetry.
3. To validate the port configurations, click Next. If AFM finds errors, correct them to continue to the
Output screen.
Designing a Fabric
83