Users Guide

• The 40G ⇨10G Split uplink bandwidth range is 2–32. This setting is not applicable to N3048,
N3048P, N3024P, N3024F, or N3024 switch models.
• The 40G uplink bandwidth range is 2–8. This setting is not applicable to N3048, N3048P,
N3024P, N3024F, or N3024 switch models.
• The 10G uplink bandwidth range is 2–32. This setting not applicable to Z9500 or S6000 switch
models.
• The Inter Chassis link range is 2–16.
The Allocated column displays the total amount of configured uplink bandwidth (in GB).
6. The 10 G Uplink Physical Type setting appears if the selected switch has 10G ports of both physical
types. In this setting, you can customize the 10G physical type as either Copper or Fiber
NOTE: You cannot change the physical type for an uplink after the fabric is pre-deployed.
7. Review the values and click Next to go to the Advanced Access Config screen.
Advanced Fabric Design — Advanced Aggregation Config (Three-Tier Topologies)
On the Advanced Access Config screen of the Fabric Design wizard, you can:
• Add aggregation switches
• Edit aggregation switch information
• Remove aggregation switches
The selected core switch model and the available, used, and total bandwidth values appear at the top of
the screen.
Adding Aggregation Switches
Figure 27. Advanced Aggregation Config Screen (Three-Tier Topologies)
1. In the upper left of the Advanced Aggregation Config screen, click Add.
The Add Switch Unit dialog box appears.
Designing a Fabric
71