Users Guide

NOTE:

• AFM does not validate whether the specified number of licensed ports is correct for the

switch. An incorrect setting causes the fabric deployment to fail.

• This setting applies for both members in VLT mode.

• You can edit this value without restriction before beginning pre-deployment steps for the

switch. After pre-deployment begins, you can only edit the number of ports licensed

upwards (for example, 36–84).

4. The default switch names are FabricName—Agg-1 and FabricName—Agg-2. To customize the

switch names, enter a name in each of the Switch Names fields.

5. In the Port Specification (per switch) section, configure the number of ports for uplinks and inter

chassis links in the appropriate entry fields. If available for a particular switch configuration, you can

also select the number of split ports.

Table 25. Support for 40 GB to 10 GB Split

Core Switch Aggregation Switch

Z9500 S6000 S4820 S4810 S4048–ON S3048–ON

Z9500 S S S

S6000 S S S

S4820 S

S4810 S S S

S4048–ON S S S S

N4000 S

”S” denotes support for 40 GB to 10 GB split.

Table 26. Support for 40 GB to 10 GB Split (Continued)

Core Switch

S60 S55 MXL N4000 N3000 N2000

Z9500 S S S S S S

S6000 S S S S S S

S4820 S S S S S

S4810 S S S S S S

S4048–ON S S S S S S

N4000 S S S S S S

”S” denotes support for 40 GB to 10 GB split.

NOTE:

• Configure at least two inter chassis links and two uplinks.

• All values must be even.

• You cannot edit the Remaining Ports field.

• The maximum configurable bandwidth is 320 GB.

• Inter chassis links do not support 40G ⇨10G Split.

Designing a Fabric