Users Guide

Switch Deployment Status Description Requires
Action
Recommended Actions
REDEPLOYMENT
REQUIRED
Re-deployment of the
switch is required
Yes Restart switch deployment.
NOTE: Verify that the switch
is not in BMP mode.
1. Navigate to Network > Fabric
Name > Configure and
Deploy tab by selecting the
switch from the list.
2. From the Deploy Fabric
drop-down menu, select
Deploy and Validate.
3. On the Deploy tab, select the
switch and click Deploy
Selected.
Deployment Task Errors
Table 65. Deployment Task Errors
AFM
Deployment
Task
Error Status Recommended Action
Verify switch
eligibility
Eligibility check for
deployment: Failed
Verify that the VLT switch deployment has a management
IP for all peers.
License
installation task
for Z9500 series
switches
License upgrade: Failed Verify that valid license file appears in pre-deployment for
selected device.
Ping verification Ping verification: Failed Verify that the DHCP offer was received on the device
console. Power cycle if needed.
Telnet/SSH
connectivity
verification
Telnet/SSH session
verification: Failed
Verify Telnet/SSH connection and that the DHCP offer was
received on the device console. Power cycle if needed.
Reset to factory
defaults
Reset to factory defaults
task: Failed
Verify Telnet/SSH connectivity and redeploy.
Minimal
configuration
upload to switch
Minimal config upload:
Failed
Verify Telnet/SSH connectivity and redeploy.
Minimal config upload
on Unit-1: Failed
Verify Telnet/SSH connectivity and redeploy.
Reload of switch Reboot of switch: Failed Verify Telnet/SSH connectivity and redeploy.
Boot image
error
Boot image was not
loaded from flash
1. To change the boot image path to flash, enter
CONFIG mode and use the following CLI command
through console session: no boot system stack-
unit 0 primary tftp://10.16.148.24/FTOS-
SE-9.5.0.0P3.bin
182
Troubleshooting