Users Guide

Aborting Deployment
1. From the menu, click Network > Fabric Name and then the Configure and Deploy tab.
2. From the Deploy Fabric drop-down menu, select Deploy and Validate.
The Deploy and Validation dialog box appears.
3. On the Deploy tab, select the switches.
4. Click Abort Selected.
5. In the confirmation dialog box, click Yes.
Advanced Configuration
To perform the following tasks, use the Advanced Configuration screen:
• View the Auto-Generated Configuration
• Associate the Templates to Fabric Switches
NOTE: Create a template for the fabric before associating it to the fabric. For more information,
refer to the Adding Templates section in Managing Templates.
• Add the Switch Specific Custom Configuration
• Preview the Combined Configuration
View the Auto-Generated Configuration
1. From the menu, click Network > Fabric Name and then click the Configure and Deploy tab.
2. From the Deploy Fabric drop-down menu, select Advanced Configuration.
The Advanced Configuration dialog box appears.
3. Click Auto-Generated Configuration.
4. Click View Auto-Generated Configuration link and wait for the configuration to appear.
Associating Templates
Associate one or more existing configuration templates to the entire fabric, all spines, all leaves, all
aggregation switches, all core switches, all access switches, or a set of switches. If you associate a
template with an entire fabric or all spines, all leaves, all core switches, all aggregation switches, or all
core switches, the template is automatically applied to all new switches so you do not need to create
new associations manually.
NOTE: Each template can have only one association per fabric. AFM does not support template
ordering for command sequencing. If you want to order templates for command sequencing, Dell
Networking recommends manually combining the templates into a single template.
1. Navigate to the Network > Fabric Name > Configure and Deploy screen.
2. From the Deploy Fabric drop-down, select Deploy and Validate.
3. On the Deploy tab, click Advanced Configuration.
4. Click Associate Templates to Fabric Switches.
The Associate Templates screen appears.
5. Click Add Association.
6. In the Template Name drop-down menu, select a template.
7. (Optionally) In the Comments field, enter any comments for the template.
8. In the Select Association area, select one the following options:
146
Configuring and Deploying the Fabric