Users Guide

• L2 — Configures Layer 2 uplinks for a Layer 2 fabric. This option is disabled by default on a Layer 3
Distributed Core fabric.
• L3 — Configures uplinks for a Layer 2 VLT or Layer 3 Distributed Core fabric. If you select the L3
option, the Uplink Configuration screen displays additional options to configure the Layer 3
protocol settings.
5. In the Protocol Settings area, select Static Routes or routing protocol (OSPF, IBGP, or eBGP) for the
EdgePort uplinks.
6. If you select Static Routes, AFM displays the Static Route Configuration section. Do the following
steps:
Figure 66. Static Route Configuration Screen
a. Click Add to configure a static route.
The Add Static Route dialog box appears.
Figure 67. Add Static Route Dialog Box
b. For static routes, enter the destination network and the next hop. If you select Default Route,
AFM automatically populates the destination network field as 0.0.0.0/0.
c. Click OK.
d. Repeat steps a-c to add an additional static route. You can configure up to 10 static routes for
each aggregation switch.
You can edit a configured static route by selecting it and clicking Edit; you can delete a
configured static route by selecting it and clicking Delete.
7. If you select a routing protocol, do the following:
• Enter settings for Area ID or Local AS Number and Loopback IP Address Range/Prefix.
128
Configuring and Deploying the Fabric