Owner manual

• Assign initiators to the BLUE2 group.

• Create a LUN for the

BLUE2 initiators to access the Test2 volume.

Here is the script that does the tasks:

profile:create reliable_performance

volume:create --cluster Test2 595 pool_md3

inigroup:create BLUE2

initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:ca IONb2_1

initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:cb IONb2_2

initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:c8 IONb2_3

initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:c9 IONb2_4

initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:ca --id IONb2_1

initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:cb --id IONb2_2

initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:c8 --id IONb2_3

initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:c9 --id IONb2_4

lun:create --all-targets --blocksize 512 Test2 BLUE2

SOFTWARE UPDATE

For more information on the software update process, see Software Commands in the

Command-Line Reference section.

If your current software version is earlier than 2.2.0, do not use the steps in either this guide

or the ION Accelerator GUI Guide to update the software. Instead, refer to the current ION

Accelerator Release Notes for the two-part update procedure.

To do a non-disruptive software update, follow the steps below (refer to the instructions for each

command for more details).

1. Obtain the ION Accelerator build file (

.iop) from Fusion-io Customer Support.

2. Log in to each node that is to be updated, using the physical IP address of the node.

3. Copy the

.iop file onto the local ION Accelerator node. To do this, run the following CLI

command (assuming an update to version 2.4.0):

soft:upload

This will place the .iop file under /home/admin.

4. To perform the update for the first node, run these commands:

soft:apply

5. Wait until the update is complete.